In SX Microcontrollers, SX/B Compiler and SX-Key Tool, tdg8934 wrote:

Bean,

Here is an update:

I checked all the pins (RB0-RB7, RA2 and RA3) on the SX-28 itself (pins 10-17, 8 and 9) AND on the PDB socket for close to 5v and using the PDB X9 buttons, get 0v when pushed. This acts as expected. I have checked the Audio out and heard it on PONG so this works.

I ran the SX-key through the DEBUG and it works ok (idle, walk, run, etc). [b]However, I ALWAYS have to have a resonator installed to see the video displayed.[/b] 

The new Sketch program does allow me to draw and erase and move it up/down/left and right. This program appears to work. 

The Flip it program works up/down/left/right and fire. This program appears to work.

The Pong program works for up/down as expected. This program appears to work.

On the Drive program - it did not  work for any of the up/down/left/right buttons only fire (RA.2). However, after loading in all the programs a few times, it started to work for left/right and fire which is probably the expected keys (up/down? - I don't know). Anyway perhaps the SX-28 needed to be "flushed out" or something. All is working with the exception of the needing to have a resonator to see video. 

 

Ideas? Comments?


Thanks.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=137918#m138279

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2006 (http://www.dotNetBB.com)