In SX Microcontrollers, SX/B Compiler and SX-Key Tool, jdemeyer wrote:

Thanks for the reply!

I was thinking that I could set up both timers in Capture/Compare.  I want to connect Timer 1's Compare Output to Timer 2's External Event Clock Source.  Both of these are output pins (RB.6 and RC.3, respectively).  When Timer 1 reaches my compare value, it should "toggle" RB.6, and Timer 2 should see that as a transition and increment its count.  In this manner, I wouldn't have to have a counter in RAM that I maintain - I could set a compare value on Timer 2 and receive the interrupt when there is a match (but I digress).

I wasn't sure if the transition on RB.6 is low to high, or low to high to low again.  I wasn't sure what the documentation meant by "toggle". 

Joe

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=138101#m138106

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2006 (http://www.dotNetBB.com)