M. Adam Davis wrote:

>It sounds like you sent the eagle brd file (and maybe the gerbers) and
>they used the eagle brd file with their own gerber generation ULP to
>make gerbers that they then fabbed the PCB off of.  In this case their
>ULP may have rendered the "solid" area as a series of parallel lines
>and messed up on the width of the lines.  This could be due to the way
>you defined the solid area, or it could be something their ULP does on
>purpose.
>  
>
Adam,

I provided them with Gerbers and not the Eagle files.  My reasoning was 
if the layout was fine I may wish to send the Gerbers to a different 
board house for larger quantities.

I wish I still had the boards with the discrepancies, but they are no 
longer in my possession to take another look at.  My memory on the track 
widths may be a little hazy, but I definitely remember the ground plane 
was made of parallel lines connected at each end.

Aaron
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist