In SX Microcontrollers, SX/B Compiler and SX-Key Tool, Dunnsept wrote:

I am finally putting together the complete code for my project and now am getting 
"Address 259 is not within lower half of memory page"
"Address 257 is not within lower half of memory page"
"Error 30, Pass 2 overwriting same program counter location"

In reading the docs, it says "Note that as of version 1.2, it is not (sic) longer necessary for the programmer to manually set code page addresses."

so,.... how do I get around these errors? I tried setting the address manually anyway as per the online help, but
that didn't change anything. A search on the forums only turned up a couple references saying "well, you have to setup your
code so your subroutines are in the lower half"  but the entries were for ASM and not SX/B.

I had working code and all I did was put in my ISR code. I sure hope this is a simple fix as I dont have anywhere
near complete code yet.. I still have to add in all of my PID routines and error checking.

paul...

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=133780

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2006 (http://www.dotNetBB.com)