I am attempting to program a 16F876A project with the Wisp628 programmer 
driven by xwisp2w  from http://www.robh.nl/ The '628 is connected to my 
computer through a FT232RL serial to USB connection. The device manager 
shows this serial port to be COM3. The .BAT file command I am using to 
run is xwisp2w is "com3 baud 9600 go %1" where %1 is the name of the 
.HEX file I wish to use.  When running xwisp2w it immediately errors 
"Command 'com3' unknown or not currently implemented" also "xwisp2 
failed after 0.08 seconds, rc 36". I have had good luck running this 
combination with a true serial port, but that one stopped functioning.

I am assuming the the program does not function properly using the USB 
to Serial interface. I cannot see at the above web site where to e-mail 
robh.nl to get suggestions. Anyone here have any?

Any enlightenment will be appreciated.

Vic
-- 

*____________________________________________________________________________________________*

*Victor Fraenckel
KC2GUI
victorf ATSIGN windreader DOT com**
*



-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist