In SX Microcontrollers, SX/B Compiler and SX-Key Tool, kgracey wrote:

Hey Eric,

I could imagine modifying a pair of needlenose pliers to have a right-angle on the end of both surfaces, so that both sides of the 300 mil DIP could be pressed inward the same amount. Add some type of depth stop as well. Just a thought, though there must be some off-the-shelf tool that would do the trick.

Ken Gracey
Parallax, Inc.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=130235#m130293

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2006 (http://www.dotNetBB.com)