Sorry Steve
You forgot the luminiferous aether  ...   http://en.wikipedia.org/ 
wiki/Luminiferous_aether



On 2006-Jun 11, at 13:06hrs PM, Steve Smith wrote:

1.	Eliminate the obvious! Get a cordless one then the wire (the thing
that was reused) is eliminated.

2.	Disconnect the doorbell and megger the wire establish its faulty
(resistive probably) and replace the wire.

3.	Remove the batteries and fit a battery eliminator the wire is then
not important until it fails completely.

4.	Remove the lamp from the bell push that causes the battery to
discharge.

Cant think of anything else there are only four parts in a doorbell the
battery, the bell, the switch and the wire.

Rgds Steve

-----Original Message-----
From: piclist-bounces@mit.edu [mailto:piclist-bounces@mit.edu] On  
Behalf Of
Lindy Mayfield
Sent: 11 June 2006 18:59
To: Microcontroller discussion list - Public.
Subject: [EE]: Help troubleshooting door bell

What would you do in my situation here?  We bought a door bell that  
runs on
batteries and I connected it to the wires that lead to the button  
outside.
Within a few days the batteries are dead, so it seems there is some  
sort of
short or something like that.  We just found out the previous owner  
had a
problem with the door bell, too, probably the same thing.

I'm kind stuck about how to figure out the problem and fix it.  Would  
anyone
mind please giving me some hints?

Thanks!
Lindy

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist


-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist

Gus S Calabrese
Denver, CO
720 222 1309     303 908 7716 cell
I allow everything with  "spamcode2006"  in the subject or text to  
pass my spam filters


-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist