In SX Microcontrollers, SX/B Compiler and SX-Key Tool, kmonsx wrote:

I've been using the SX28 for awhile with virtually no problems on the eval board.
 

I went away from my current project for awhile, came back, and now the debugger reports "SLEEPING" at the top of the debug window during a certain point in execution.

 

I'm using the latest version 3.1 IDE, and just reinstalled for the heck of it.  Same problem.

 

I'm sure my code is actually running, because it takes one of my "commands" via some UART(bit-banged non-interrupt based) code.  I can't step through it because of the fact that its a uart.  Right after the command is read, it immediately goes into "SLEEPING" mode, and everything halts.

 

I'm not using any watchdog timers or anything of that sort.

 

I've never seen "SLEEPING" across pretty extensive usage of the debugger.

 

What's going on here?

 

Thanks.

 

Keith

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=130012

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2006 (http://www.dotNetBB.com)