In SX Microcontrollers, SX/B Compiler and SX-Key Tool, bean wrote:

If the interrupt take "about" the same amount of time, you might get away with adjusting the serial baud rate. 

What you can do is keep adjusting the baud rate up in 1% increments until it starts working, then keep increasing it until it stops working again. Then use the average of the highest and lowest working values.

Bean.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=129727#m129738

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2006 (http://www.dotNetBB.com)