On 6/7/06, Padu <padu@merlotti.com> wrote:
>
> I did a couple more tests today, and I'm more inclined to say that the
> device doesn't work by phase shift. Tell me if I'm right.
> I got one axis (two wires: B and C), plugged wire B into channel 1 of my
> oscope and wire C to channel 2. Set the oscope to time base, pressed the ADD
> button and INVERT for channel 2. When I did that, the wave become a flat
> line (that's what I was expecting, since the two signals are equal when the
> device is resting). When I turned about the axis being measured, the
> horizontal flat line shifted up or down according to the direction I was
> turning the device.
> Now, if there was any phase shift, then I'd see something other than a flat
> line in this case, wouldn't I?
>
> Cheers
>
> Padu
>

Try x-y mode.

Regards,
Mark
markrages@gmail
-- 
You think that it is a secret, but it never has been one.
  - fortune cookie
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist