On Jun 5, 2006, at 11:47 AM, Stef Mientki wrote:

> I'm not too experienced with Eagle, and I want to create a prototyping 
> board,
> mainly consisting of single sided pads, with  holes, at a raster of 
> 0.1 inch.
> I need a double side board, because of some edge connectors.

What's the disadvantage of having your pads be double-sided as well?  
By the time
you pay for a double-sided board for the connectors, why not have 
double-sided pads
as well?

You can get to almost single-sided pads by setting the RESTRING 
parameters for the
top (or bottom) layer to zero.  Or, when you generate your gerbers, you 
can probably
leave out the pads/vias for the top or bottom, if the only thing you 
needed on that
layer was SMDs for the edge connectors...

BillW
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist