On 6/5/06, Stef Mientki <s.mientki@mailbox.kun.nl> wrote:
>
> I'm not too experienced with Eagle,
> and I want to create a prototyping board,
> mainly consisting of single sided pads, with  holes,
> at a raster of 0.1 inch.
> I need a double side board, because of some edge connectors.
>
> I don't know what the best way to accomplish this.
> I can think of using smd pads and place a hole over it,
> but I'm sure it'll work.
>
> What is the best solution.

For your RPD board, use a few vias till create a rectangle. Then copy
and paste the rectangle near the first rectangle. You have a double
size rectangle now. Copy it again and paste it near the existing
rectangle. You have a four size larger now. And so on till the
eurocard is filled.
When create the gerber use one layer so the vias metalisation will be lost.
Smd pads with holes will generate error.

Vasile

>
> thanks,
> Stef
> --
> http://www.piclist.com PIC/SX FAQ & list archive
> View/change your membership options at
> http://mailman.mit.edu/mailman/listinfo/piclist
>
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist