Hi Bill
I'm using 16F676 and I failure to verify if I let the ICD2 choose the memory
locations.
If I set it to manual and choose the full program range it works fine.
I'm not sure what is going on but apparently the ICD2 is programming less
memory than it is checking or that needs to be programmed.

 
 
 
 
Phillip
Things should be as simple as possible but no simpler
 
 
 
Phillip Coiner
CTO, GPS Source, Inc.
 
 
Your source for quality GNSS Networking Solutions and Design Services, Now!
-----Original Message-----
From: piclist-bounces@mit.edu [mailto:piclist-bounces@mit.edu] On Behalf Of
William Chops Westfield
Sent: Saturday, May 27, 2006 2:33 AM
To: Microcontroller discussion list - Public.
Subject: [PIC] pickit 1 failure modes

Is there a known failure mode for the pickit one where a 12F675
will fail to verify, even though it seems to work?  This has been
happening recently and I shrugged it off, but the resulting PICs
have seemed to become "flakey" over time (or stop working entirely),
and I'm wondering whether they were properly programmed in the
first place.  (unfortunately, the PICs are in an app where there
are other reasons they might fail as well...)

BillW
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist