Hi:

I'm trying to get Myke's 2-wire LCD interface working with a 16F88 and 
4x20 LCD.
One of the debugging steps is to set  _CONFIG1 to INTRC_CLKOUT both in 
the code and in MPLAB v7.30 configure/configuration bits.
But when I put a scope on pin # 15 (RA6) there's no clock out, but there 
are LEDs blinking etc that make be think the chip is doing something.
--snip--
    __CONFIG    _CONFIG1, _CPD_OFF & _CP_OFF & _DEBUG_OFF & _INTRC_IO & 
_LVP_OFF & _MCLR_OFF & _PWRTE_OFF & _WDT_OFF & _WRT_PROTECT_OFF & 
_INTRC_CLKOUT

--snip--
  org    0
  nop
  nop

; Now set 4 MHz clock
    bsf    OSCCON, IRCF2
    bsf    OSCCON, IRCF1
    bcf    OSCCON, IRCF0
    nop    ; allow some time for oscillator to settle
    nop
--snip--
Any thoughts as the why there's no clock out?

Thanks,

Brooke Clarke

-- 
w/Java http://www.PRC68.com
w/o Java http://www.pacificsites.com/~brooke/PRC68COM.shtml
http://www.precisionclock.com

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist