In SX Microcontrollers, SX/B Compiler and SX-Key Tool, _BPM_ wrote:

I actually just figured it out.


I have multiple displays, and when I first started the sx-key software the default pop up talking about needing to set up default values shows up.  I can click ok....  But then the config window shows up somewhere that I can't see.   So one is forced to try to close the program from the taskbar, and that results in an access violation.   I was able to fix it by disabling all of my displays except my single display, then restarting sx-key, setting my defaults, closing the program, and then reenabling my displays.    After all this, the sx-key software shows up properly.

Thanks everyone for the responces.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=127071#m127781

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2006 (http://www.dotNetBB.com)