In SX Microcontrollers, SX/B Compiler and SX-Key Tool, bean wrote:

Sounds like you have the resonator connected correctly.

You MAY (or may not) need a resistor across the outermost pins of the resonator. It usually works without a resistor, but it is recommended. 

The MCLR pin must be connected to Vcc with a 10K resistor.

You should also use one of the brown-out-reset settings on the device line of your program. BOR42 if you are using 5volts.

Bean.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=125625#m125736

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2006 (http://www.dotNetBB.com)