In SX Microcontrollers, SX/B Compiler and SX-Key Tool, John.Gray wrote:

Jon,

  I'm still working on the SX/B SUB command and the use of _PARAM, _PARAM1 and _PARAMCMT.  I've plugged the BS2 into the PDB and I'm going back through the books and will start doing some of the examples using DATA and LOOKUP.  I have been trying to use the code examples found under the LCD section, when I try and run the code, I get errors all over the place, 

LCD_CCHAR CC0
LCD_CCHAR CC1
LCD_CCHAR CC2
LCD_CCHAR Smiley
line 107, 108, 109  Error 8, Pass 1 Invalid Parameter "CC0"
line 107, 108, 109  Error 10, Pass 1 Invalid number of Parameters

READ Msg2 + idx1, newChar
line 124, Error 8, Pass 1 Invalid Parameter "Msg2"

Like I said earlier, this is something I have no idea how to do, but with the amount of info out there, I will, and as always, when I get stuck, lost or a well placed kick in the rear, I will turn to here

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=125563#m125594

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2006 (http://www.dotNetBB.com)