On 4/29/06, ramzi76 <ramzi76@ieee.org> wrote:
>
> Hi All,
>
> I'm new to PICs and I'm facing a problem programming the 16f84a PIC:
> I built a paralel port programmer which is compatible with the ProPic2
> hardware
> I used the Winpic800 software, but when I read the PIC, I get at address 0
> (program code) the value of the device ID (0x0560) and I can't program any
> hex file since I must first write to the reset address (0x0)
> I tried the 16f648a pic, and the problem was the same
> Does anyone have any clues what is wrong??.
>
> Regards,
>
> Ramzi.
> --
> View this message in context: http://www.nabble.com/winpic800-and-propic2-t1528935.html#a4153271
> Sent from the MicroControllers - PIC forum at Nabble.com.
>

You can try to use some other programs like IC-Prog or WinPIC. You may
also want to check out your connections.

By the way, I still do not like Nabble.com. I guess it is better to
subscribe to PIClist directly. Anyway it seems the admin has no
problems with Nabble so I think it is up to you to decide.

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist