In SX Microcontrollers, SX/B Compiler and SX-Key Tool, two_shoes_2002@yahoo.com wrote:

I get the error message "Unable to assemble due to some errors in the source code." when I attempt to run the following code.  It highlights the first line.
[code]
	device		sx281,oschs3
	device		turbo,stackx,optionx
	IRC_CAL		IRC_SLOW
	reset		start_point
	freq		50000000	; 50 MHZ


	org		0

start_point	mov	!rb,#0
		mov	!rb,#0
		sleep
[/code]

I typed this right out of the [i]Exploring the SX[/i] book.  What am I doing wrong here?  Maybe it's just too late and the letters all look alike, but I don't see any difference.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=121779

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2006 (http://www.dotNetBB.com)