> Attached is the block diagram of a PSU I need to build. The bit
> I'm missing is "?"
>
> Input - 12V or 24V automotive/transformer tolerant, down to
> 8V-ish if possible
>
> Output - SLA charger/float, say 0.5A for charging, and 5V,
> around 0.1A. The nominal 12V is also used for 4-20mA
>
> It's necessary for it to be able to recharge a 12V SLA from a 12V
> automotive battery
>
> Any recommendations for this front end ? It doesn't have to be a
> 1-chip solution, can be reasonably complex. Lowest quiescent
> would be best, as other components are planned to be asleep to
> save power if the whole thing isn't on mains, which is when it goes
> over to the SLA as the primary supply

Hi Joel,

Maybe you'll get some inspiration from my car's computer/mp3 player -
power supply is 12 in and 12 out up to about 8 amps.

http://www.bobblick.com/techref/projects/mp3book/mp3book.html

Cheers,

Bob

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist