Brooke,

  Not sure what you consider prohibitive but you might take a look at 
BatchPCB (www.batchpcb.com) from Sparkfun.  They offer inexpensive PCB's 
in about 3 weeks.  At $2.50 per square inch plus $10.00 setup fee plus 
shipping it's not too bad.

Phil

Brooke Clarke wrote:

>Hi:
>
>I'd like to make prototypes to try out some ideas where both through 
>hole and surface mount parts are needed. 
>If a custom PCB is made for each of the tries the cost is prohibitive. A 
>PCB that combines both types of parts has been designed, see:
>http://www.pacificsites.com/~brooke/BTPS.shtml#PB  Is a mixed part 
>prototype board available?
>
>Thanks,
>
>Brooke Clarke, N6GCE
>
>  
>


-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist