I suspect you either A: blew the pin, B: did'nt set the pin direction 
register correctly, C: have your scope probes in 10x mode


>From: Yau <ygarba@gmail.com>
>Reply-To: "Microcontroller discussion list - Public." <piclist@mit.edu>
>To: piclist@mit.edu
>Subject: [PIC] Very low output on ccp1 for pwm1
>Date: Sun, 12 Feb 2006 07:02:19 +0300
>
>Hi All,
>I setup my PIC16F876 for pwm. When I observed the output with a scope, the
>output is very low (just about 450mV for high). However, the frequency and
>duty circle seems okay. This is even without attaching any load to the pin.
>
>Many thanks for your anticipated help.
>
>PS: Am a bit new to PIC
>
>--
>Kind Regards,
>
>Yau
>ygarba@gmail.com
>--
>http://www.piclist.com PIC/SX FAQ & list archive
>View/change your membership options at
>http://mailman.mit.edu/mailman/listinfo/piclist


-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist