Phil Keller wrote :

> The way I am interpreting this is that the device will not 
> be damaged at 25mA but the Vol could be very high and
> would/could be different from one device to the next.

Define "very high" !

> To guarantee a logic low (Vol <= 0.8) I need to keep the 
> current down to 8.5mA.

Why does it matter ?
Ae you going to use the pin as a LED-drive and as a logic
output pin at the same time ?

Note also that modern high-efficiency LEDs are
perfectly visible down to a few mA's.

Regards,
Jan-Erik.



-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist