Just set an org at 03fff, and install the instruction.
Try it in MPLAB, compile it, then look at the PGM
array. It will be right there.

--Bob


Dennis Crawley wrote:

>Hi,
>The original calibration value of a 12f675 is seems to be erased.
>The original value it was read it with MPLAB and PS+, and it was "retlw
>0x48" at 3fff.
>I wonder if it is possible to re-write this value.
>
>The pic was also missconected "once" on the protoboard: Vdd to pin 2 and gnd
>to pin 7 (shifted one hole), It was reprogrammed and that pins work nice...
>
>The main problem now is when the ps+ finish to verify, there are a lot of
>bad memory locations compared with the program. If it done twice, the pic is
>succesfully programmed... and this never happened before, as long as i
>recall.
>
>No icsp is used.
>
>Any comments about trust on "that" pic or about how to reprogram the osccal
>is
>apreciated.
>
>Dennis Crawley
>Argentina
>
>ps: no generalisimos arround,... but is wost.
>
>
>
>
>  
>


-- 
Note: To protect our network,
attachments must be sent to
attach@engineer.cotse.net .
1-520-850-1673 USA/Canada
http://beam.to/azengineer

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist