This is a strange little problem, and I'm trying to figure out the best 
way to do it.  I have a little prototype board with a 40-pin socket 
soldered into it (originally there was an 18F452 plugged into it).  For 
an project that I am doing, I want to plug a 28-pin dsPIC30F3013 into 
that socket.  Obviously some pins will go unused, but that is OK.  One 
way, which seems pretty awful, would be to just hard-wire a 28-pin 
socket to the appropriate pins of  the 40-pin socket.  Seems like there 
should be a more elegant way, though.  Ideally, I'd like to do it in a 
manner which will allow me to go back to plugging the 18F452 in when I'm 
done.  Any suggestions?

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist