At 03:05 PM 1/10/2006, Mauricio Jancic wrote: > Can anyone tell me what would be the minimum distance between >BNC connectors? I have a panel with 16 columns of 3 rows of connectors and I >would like to know the minimum distance. anyone? The permanently mounted video switchers I've seen use 0.75" spacing (I measured it). Hanging on a hook near the rear of the switcher is a cute tool used to twist the BNC connectors on and off. Think of a sleeve that is knurled on the inside to match the knurl on a standard BNC connector. That sleeve has a slot wide enough to pass the video cable (Belden video blue - don't remember the number). The sleeve is welded to the end of what looks like a long screwdriver. In fact, just like Its darned easy to reach in and loosen or tighten any connector you wish to - even in the middle of the panel. dwayne -- Dwayne Reid Trinity Electronics Systems Ltd Edmonton, AB, CANADA (780) 489-3199 voice (780) 487-6397 fax Celebrating 21 years of Engineering Innovation (1984 - 2005) .-. .-. .-. .-. .-. .-. .-. .-. .-. .- `-' `-' `-' `-' `-' `-' `-' `-' `-' Do NOT send unsolicited commercial email to this email address. This message neither grants consent to receive unsolicited commercial email nor is intended to solicit commercial email. -- http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist