In SX Microcontrollers, SX/B Compiler and SX-Key Tool, Coriolis wrote:

Tacking two opposite corners with low temp solder and flux, fluxing all pins, wave solder each line without touching actual pins (pad only to deposit solder), go back over with dry tip along pin->pad joint. Works very well, vitually no bridging, most bridging occur when you hop up onto the pins only. Whole process takes about a minute.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=103800#m103816

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2006 (http://www.dotNetBB.com)