In SX Microcontrollers, SX/B Compiler and SX-Key Tool, Rsadeika wrote:

I tried changing the value from T(true) to N(inverted), on both boards, it still did not work. If I put in < 255, when the setting was N, then I got some activity. I guess more detail is needed , on both boards I have the pullups activated, both are set for internal RC at 4MHz, and I have one wire to the respective pins. One board sends the data, and the other board is in a loop, waiting for the data to arrive.

Since, in the setup that I have, when I change the conditions from '=' to '<' or '>' it breaks out of the loop, meaning something has arrived. When I use "A" or 65 as the value, on the receiving end, I am not getting anything, is this a baud problem, or something else. In one of the other posts there was some mention about using serin/serout while using the internal RC, could that be the problem. Since I only have one 4MHz resonator, I can not have both at oschs2 setting.

Just to make sure that my thinking is correct, T(true) = msb|lsb, and N(inverted) = lsb|msb. Anything else of significance that I should know about these baud modes. I am not certain as to how this would have any impact on an SX to SX communication. Now I am stumped.

Any help would be appreciated.

Thanks

Ray

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=103038#m103114

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2006 (http://www.dotNetBB.com)