In SX Microcontrollers, SX/B Compiler and SX-Key Tool, inaki wrote:

I am using a serial device connected to a professional dev board, to the serial port (the max232 chip).
 

As baud string setting I am using the following:

 

"N115200"

 

but it does not work.

If, however, I use Hyperterminal (the Windows communication program) to communicate with the same device, it does work.

 

To test if it works I can send a single byte to perform a complete function, so it is fairly easy to test.

 

The target device supports only 115200 bauds, unless firmware is upgraded.

 

Is "N115200" the standard baud string to access a conventional serial device at this speed ?

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=101969

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2005 (http://www.dotNetBB.com)