> It turns out that the connectors are a limiting factor on most of the
> boards when you go DS, so even with relatively "big" design rules, I
> managed to fit 14 boards (12 boards, two with 2 copies each) on an
> Olimex 100x160mm panel.  (maybe.  This hasn't actually been 
> fabricated,
> and I'm not sure there's enough space between the boards for them to
> be cut apart reliably, and they're not straight lines either, so...)

Olimex won't accept this. They cut, not route, so they can do only what
can be done in a number of guiotinne-style cuts: no partway cuts. But
they need very little space between the PCBs, IIRC 0.5mm. You can find
that figure somewher on their site.

Wouter van Ooijen

-- -------------------------------------------
Van Ooijen Technische Informatica: www.voti.nl
consultancy, development, PICmicro products
docent Hogeschool van Utrecht: www.voti.nl/hvu
 

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist