> As long a the laser gurus have come out of the woodwork, I was wondering
> what would be the best way to obtain a laser that would cut light
> weight materials
> such as thin wood venier or thin plastic ( approximately 1mm ).  Low
> cost is the operant
> concept here.
>
> AGSC     aka Gus Calabrese

Hi Gus,

If you've done it before, have a good scrapbox, shop carefully and are a
little lucky, you can put together a laser like that for about $1000. But
typically you'd need to spend about five times that amount, and it would
still not be a turn-key operation.

Cheers,

Bob



-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist