In SX Microcontrollers, SX/B Compiler and SX-Key Tool, Rsadeika wrote:

Bean,

Thanks for the detail. As to the 1st point, I tried RESET Main instead of RESET 0, that corrupted my results. The 2nd point, I finally figured that one out, and my code is exactly like your code. 3rd point, I wanted to create some code that would tell me that my IR detector was working properly (I already fried two of them) as I pushed a button on the remote controll. When the snippet is working, and I hold the button down, the LED flashes, as expected, I wanted to put in a slight pause so the LED stays on for a second. I am trying to lay the ground work for a functioning IR remote controll program in assembly. 

After I get this small snippet to work then I want to go ahead and add the rest of the code, capture the remote controller command code, and start working with the data.

One way to learn is if you build it yourself, hopefully, this is not re-inventing the wheel.

Oh, I tried Guenthers tut003.src, on the SX52 proto board, that did not work either. The LED turned on and stayed on. That code is supposed to pause, turn the LED on, pause, and turn the LED off. So, there is something strange that is going on, that is what is so frustrating.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=100433#m100640

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2005 (http://www.dotNetBB.com)