On 12/3/05, Olin Lathrop <olin_piclist@embedinc.com> wrote:
> John Nall wrote:
> > I don't think the board is trying to control that line.
>
> But that's exactly what the job of the power supply is.  The EasyProg is
> trying to make Vdd one voltage and your power supply another voltage.  At
> best nothing blows up.  In any case programming is unlikely to work.
>

Is it possible to add a command line switch to tell that EasyProg not to
vary voltage and/or not to control the voltage? I know this may require
a firmware update as well.

I think it is good to have a power supply and variable Vdd. This is one
aspect where EasyProg better than Wisp628 (the other is the dsPIC/PIC12
base line support). But it may be good to have the option to switch this off.

Regards,
Xiaofan

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist