Hi,

I've a problem with my board, I've created a board like this:
http://pic18fusb.online.fr/wiki/uploads/Minimal-for-USB-Bootload.gif
with the only difference I've added an ICD port for programming en 
debugging, and the PIC is changed to an 18F2550.

I try to get the Microchip bootloader firmware to run, like described on 
this page:
http://pic18fusb.online.fr/wiki/wikka.php?wakka=UsbBootload
The problem is that I get an error from windows: "USB Device Not 
Recognized", and when I check for VID and PID in Device Manager it says 
VID_0000&PID_0000.

I think I've configured the configuration bytes wrong like the person on 
the Microchip forum: http://forum.microchip.com/tm.asp?m=125094, but I 
dont get it working. I've tried several possibilities, but whit no 
success. I think this are the configuration bytes which cause the error, 
but I don't know which is wrong:

Full-Speed USB Clock Source Selection: Clock src from 96MHz PLL/2
CPU System Clock Postscaler: [OSC1/0SC2 Src: /1][96MHz PLL Src: /2]
96MHz PLL Prescaler: Divide by S (20MHz input]
Oscillator: HS: HS+PLL, USB-HS
USB Voltage Regulator: Enabled

Can anyone help me with these configuration bytes, or suggest it's 
something else which causes this error?

Paul

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist