In SX Microcontrollers, SX/B Compiler and SX-Key Tool, randall.harris wrote:

I have a very peculiar problem.  I am trying to get rc.3 bit to flip/flop.  I have a wire from rc.3 to a breadboard.  Attached to the same row is one wire that is attached to a parallax oscilloscope.  A third wire is attached to a cable that goes to a connector.  RC.3 flip flops when in the walk mode.  It does not flip flop when in the run mode.  However, if I remove the third wire the oscilloscope does show a flip flop.  Whenever I reattach the wire it stops.  The best I can tell, the wire does not have a stray voltage or ground associated with it.  ANY IDEAS?

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=91494

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2005 (http://www.dotNetBB.com)