In SX Microcontrollers, SX/B Compiler and SX-Key Tool, RickB wrote:

DO NOT USE ACID FLUX! If you find it necessary to use acid flux on a circuit board, you are doing something very wrong or you have a very oxidized board. On unoxdized boards with new parts, thinned rosin flux will work fine.

This is VERY bad advice!

Rick

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=86586#m90900

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2005 (http://www.dotNetBB.com)