On 9/28/05, pic@amusementcity.com <pic@amusementcity.com> wrote:
> Hi,
> I've just finished designing a board with PIC on it using Protel DXP. ( I
> finished with layout too).
> My question is how can I check if my board will work after manufacturing it.

Unfortunately there is no simulation to check a full board functionality.
But there are some simulation which can be done on schematic structure
using equivalent pspice programs or RF simulation software.
AFIK protel allows you a gerber visualisation which is great.

cheers,
Vasile


> I would like to run some simulations to check if everything is as it should be
> on board.
> Is it possible with Protel and what kind of simulations I run?
>
> Thank you,
> Sam
>
> ----------------------------------------------------------------
> This message was sent using IMP, the Internet Messaging Program.
>
> --
> http://www.piclist.com PIC/SX FAQ & list archive
> View/change your membership options at
> http://mailman.mit.edu/mailman/listinfo/piclist
>

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist