Hi,
I've just finished designing a board with PIC on it using Protel DXP. ( I
finished with layout too).
My question is how can I check if my board will work after manufacturing it.
I would like to run some simulations to check if everything is as it should be
on board.
Is it possible with Protel and what kind of simulations I run?

Thank you,
Sam

----------------------------------------------------------------
This message was sent using IMP, the Internet Messaging Program.

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist