In SX Microcontrollers, SX/B Compiler and SX-Key Tool, Peter Van der Zee wrote:

Hi AJ;

One of my companies (flexcim.ca) does contract plastic injection molding. If it is a volume product you are making, then custom parts make sense, otherwise it is probably too expensive. The individual plastic pieces are perhaps one or a few dollars, but making the mold to create them can range from $10,000 for a simple mold to many times that for a  complex mold.........probably not what you had in mind.

Cheers,

Peter (pjv)

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=85645#m85658

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2005 (http://www.dotNetBB.com)