In SX Microcontrollers, SX/B Compiler and SX-Key Tool, Coriolis wrote:

There are techniques to make the job easier, the quickest to master is the drag soldering method as shown in [url=http://www.howardelectronics.com/xytronic/Images/Drag%20Soldering%20107.wmv][u]this video[/u][/url]. Key is to use flux (water soluable or no clean), don't ride too high on the pins (bridging occurs), and most important: make sure the chip is properly aligned.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=85042#m85059

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2005 (http://www.dotNetBB.com)