I tried that and still no success.  BUT when I disconnected the ICD2 
clone it started to work.  Doesn't make sense since I had a resistor 
pulling it to Vdd and a volt meter read 5v but sometimes I just have to 
take success where I find it.  If I have the time I am going to go back 
and remove the CMCON setup but I need to make some progress.  Too much 
time lost getting no where.

  Thanks for the suggestion.
Phil

William Chops Westfield wrote:

>
> On Aug 15, 2005, at 9:12 AM, Phil Keller wrote:
>
>> I am trying to use the weak pull-ups in the PIC16F676 device.
>> I have set RAPU*=0, WPUA0=1 (the default) and TRISA0=1.
>
>
>> BUT, the real device and the simulator do not have them being
>> pulled high. With A0 floating it measures less than 0.5v.
>
>
>>  Is there another bit that needs to be set someplace?
>
>
> Have you disabled the other peripherals that share those pins?
> I think the troublesome one is usually the analog comparator...
>
> BillW
>

-- 
===========================================
PK Consulting
Phil Keller
Fremont, Ca

Phil@PKConsulting.net



-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist