On 8/2/05, Steve Murphy wrote: > There's the rub (no pun intended). I tried Q-Tips dipped in acetone and > that removed the toner off of the pads all right, but it also smeared it > all over the rest of the board, making a terrible mess. So I ended up > wiping it all off all at once because it wasn't so messy. So, no, I > haven't figured out an easy way to do that. I suppose you could print > out a solder mask and re-iron it on, but that sounds like a lot of trouble. I've printed a silkscreen layer once...it sort of worked, but I was putting it on the blank side of single sided board, and I should have slightly scuffed the surface for better adhesion I think. Josh -- A common mistake that people make when trying to design something completely foolproof is to underestimate the ingenuity of complete fools. -Douglas Adams -- http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist