Roy,

>Great news Vic - but can you explain the steps to follow in order to
>program a chip from a hex file.

I normally do not use MPLAB to burn my PIC software. When I was using =
MPLAB, I think I selected Programmer from the main menu bar and then =
selected the appropriate hardware [ICD2 in this case]. After selecting =
the proper programmer, a second selection of Programmer has a entry for =
configuring the programmer.  I don't remember past that. I am now using =
a Wisp628 programmer with XWisp2. Much easier. The baggage of the MPLAB =
is not needed to burn a Hex file with the program generated by =
mikroPascal or mikroC compiler. The '628 gets the job done for me. My =
apps have a ICD2 compatable connection on-board.

Sorry I was not much help here. Perhaps some MPLAB guru could wade in!

Vic
________________________________________________________

Victor Fraenckel - The Windman        =20
victorf ATSIGN windreader DOTcom
KC2GUI                                                 =20

      Home of the WindReader Electronic Theodolite
                               Read the WIND
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist