In SX Microcontrollers, SX/B Compiler and SX-Key Tool, Tolmie wrote:

Hi,

We are converting our PCB from the SX20 to the SX48. The new SX48 based PCB doesn't work.

Am I correct in assuming that I just change SX20 to SX48 in the DEVICE section in the assembly?

Shane.

p.s. We are using the same identical I/O lines on the SX48 compared to the SX20.

p.p.s. The primary reason for the switch is double flash/ram, plus the fact that the SX48 going to be Pb-free, unlike the SX20.

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=82511

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2005 (http://www.dotNetBB.com)