In SX Microcontrollers, SX/B Compiler and SX-Key Tool, herold wrote:

I am using a simple program to output "Hello" in a loop (see attached program). Pin RB1 is connected to RX on the USB2SER chip. VCC is connected from the board to Vcc on teh USB2SER chip.

In my PC I am using the DDL driver to read the data. I am using the same Baud rate and connection settings but the data come in as unreadable characters.

I was testing a loopback with the USB2SER and the characters I send come exactly the same way back.

Is there anything I am missing here?

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=82352

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2005 (http://www.dotNetBB.com)