Thanks for the reply Jan-Erik. I found the problem, it was that my PR2=20
register was getting over written by a small number on an errant bank switc=
h=20
and most of the duty cycles I was giving it were greater than PR2.=20
 James

 On 7/15/05, Jan-Erik Soderholm <jan-erik.soderholm@telia.com> wrote:=20
>=20
> James Humes wrote :
>=20
> > I'm using a 16F913 and having
> > some trouble
> with
> > the PWM output on RC5. I had set it up and had it working,
> >
> but since then
> > have added a lot of code and somewhere along the way
> the PWM
> > broke without
> > me noticing it.
>=20
> Restore one of the backups
> of the "working" code ? :-)
>=20
> > I'll be more than happy to post code,
> but I don't want to
> > bog this message
> > down with it until I see
> that I get on the list and someone
> > is curious.
>=20
> I don't think a
> short PWM example would
> be to much. Do not post your whole code, just
> a
> short PWM test-case that shows your "problem".
>=20
> There is a good chance
> that you will find the problem
> while preparing the test-case ! :-)
>=20
>=20
> Jan-Erik.
>=20
>=20
>=20
> --
> http://www.piclist.com PIC/SX FAQ & list archive
> View/change your membership options at
> http://mailman.mit.edu/mailman/listinfo/piclist
>
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist