In SX Microcontrollers, SX/B Compiler and SX-Key Tool, circuitman78 wrote:

Sorry, I have the BASIC Stamp 2sx Module...not just the Ubicom IC.  I have not had an issue programming it with the carrier board.

Back the LCD issue; I found a few experiments (exp 11 & 12 of the Stampworks manual)  that work to some extent with the LCD module I am using (L1671).  The module is a 16x1 display however it is addressable in two lines; the 9th character being character one on the second line.  Right now, using the code "as is" from experiment 11 will only use half the display.  How do I address the other half?

---------- End of Message ----------


You can view the post on-line at:
http://forums.parallax.com/forums/default.aspx?f=7&p=1&m=59814#m80092

Need assistance? Send an email to the Forum Administrator at forumadmin@parallax.com

The Parallax Forums are powered by dotNetBB Forums, copyright 2002-2005 (http://www.dotNetBB.com)