On Sun, 2005-07-10 at 17:06 +1200, Jinx wrote:
> > While I more commonly use lower values, 10k is completely reasonable
> > in my mind for "normal" I2C speeds which are on the slower side, and
> > definitely doesn't imply running < 10khz. 
> 
> The major factor I believe is buss capacitance. PIC i/o have pretty fast
> rise and fall times so I guess they're quite low C. No or short cable
> wouldn't present too much load

True, but note that the value of the pull up is more to do with the pull
up "pulling up" the bus, then the time it takes the device to pull down
the bus.

In all applications of I2C where I've plunked down a scope the "pull
down" time by whatever device is driving is MUCH faster then the "pull
up" time of the resistors' action.

If you have a longer bus (or perhaps just an average length bus but iwth
a crap load of devices), or want to go at a greater speed, then a lower
pull up is definitely a good idea, but for more average speeds and bus
configs 10k seems reasonable. However, with all that said, unless power
is of concern, you almost never loose by using a lower pull up.

In the end it doesn't matter either way, the op found the problem. 

TTYL
 

-----------------------------
Herbert's PIC Stuff:
http://repatch.dyndns.org:8383/pic_stuff/

-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist