Thanks a lot everyone. I finally got it working. The book I was using for=
=20
reference actually had an error in it.=20
 James

 On 7/9/05, Herbert Graf <mailinglist2@farcite.net> wrote:=20
>=20
> On Sat, 2005-07-09 at 15:29 -0400, Olin Lathrop wrote:
> > James Humes wrote:
> > > I'm working with a PIC16F913 and
> > > trying to implement I2C master mode on two of its pins (SCL, SDA). I
> > > have put a 10K resistor on each line to pull it up to Vcc
> >
> > That's a pretty high value. It may cause trouble unless your bit rate i=
s
> > really slow, like below 10Kbits/sec maybe. Check the rise time on the
> > scope.
>=20
> Actually that isn't that high. For example, the MChip datasheet for the
> 24C02C EEPROM (page 4) says:
>=20
> "...the SDA requires a pull-up resistor to Vcc (typical 10k for 100kHz,
> 2k for 400kHz)."
>=20
> While I more commonly use lower values, 10k is completely reasonable in
> my mind for "normal" I2C speeds which are on the slower side, and
> definitely doesn't imply running < 10khz.
>=20
> TTYL
>=20
> -----------------------------
> Herbert's PIC Stuff:
> http://repatch.dyndns.org:8383/pic_stuff/
>=20
> --
> http://www.piclist.com PIC/SX FAQ & list archive
> View/change your membership options at
> http://mailman.mit.edu/mailman/listinfo/piclist
>
-- 
http://www.piclist.com PIC/SX FAQ & list archive
View/change your membership options at
http://mailman.mit.edu/mailman/listinfo/piclist