On 7/1/05, John Ferrell wrote: > I know laser cutting devices are available commercially, but just what are the conditions involved with acquiring a laser powerful enough to cut thin wood or engrave wood? > > The XY, CNC aspect has been well covered. > I am assuming the laser is the limiting factor cost wise. Certinaly sounds like a fun project. Here is a setup on eBay: http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&category=53141&item=7526906733&rd=1 I note that in the Q&A section lower down on the page, the seller mentions that you can get the laser (20W CO2) and power supply for $1978.00. The 50W that he has in the auction will supposedly cut plywood at 6"/sec. Pretty nifty. Bradley -- http://www.piclist.com PIC/SX FAQ & list archive View/change your membership options at http://mailman.mit.edu/mailman/listinfo/piclist